Hostname; Ifconfig - Ricoh Aficio MP161 Network Manual

Monitoring and Configuring the Printer

hostname

Use the "hostname" command to
change the printer name.
❖ View settings
msh> hostname
2
❖ IPv4 Configuration
msh> hostname "interface_
name " "printer_name"
• Enter the printer name using up
to 63 alphanumeric characters.
• You cannot use a printer name
beginning "RNP" (in either up-
per or lower case).
• The Ethernet interface and IEEE
802.11b interface will have the
same printer name.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
Interface name
ether
wlan
❖ Initializing the printer name for each
interface
m s h > h o s t n a m e
"interface_name" clear
name
58
Interface configured
Ethernet interface
IEEE 802.11b inter-
face

ifconfig

Use the "ifconfig" command to view
and configure TCP/IP (IP address,
subnet mask, broadcast address, de-
fault gateway address) for the printer.
❖ View settings
msh> ifconfig
❖ IPv4 Configuration
msh> ifconfig "interface_
name" "parameter" "address"
• If you did not enter an interface
name, it is automatically set to
the Ethernet interface.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
Interface name
ether
wlan
The following explains how to
c o n f i g u r e a n I P v 4 a d d r e s s
192.168.15.16 on Ethernet inter-
face.
msh> ifconfig ether 192.
168.15.16
❖ IPv6 Configuration
msh> ifconfig ether inet6
interface_name "
"printer_name"
The following explains how to
c o n f i g u r e a I P v 6 a d d r e s s t o
2001:DB8::100 with prefix length
64 on the Ethernet interface.
msh> ifconfig ether inet6
2001:DB8::100 64
Interface configured
Ethernet Interface
IEEE 802.11b Inter-
face