When The Optional Ieee 802.11B Interface Unit Is Installed - Ricoh Aficio MP161 Network Manual

Appendix
• Under Windows 2000/XP and
Windows Server 2003, clear the
[Form feed] check box on the [Net-
Ware Settings] tab in the printer
properties dialog box.
• Under Windows NT 4.0, clear the
[Form feed] check box on the [Net-
Ware Settings] tab in the printer
properties dialog box.
Banner page
You should not configure a banner
page on NetWare. If you want to
4
change the banner page setting, al-
ways configure it using Windows.
• Under Windows 95/98/Me, clear
the [Enable banner] check box on the
[Printer Settings] tab in the printer
properties dialog box.
• Under Windows 2000/XP and
Windows Server 2003, clear the
[Enable banner] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
• Under Windows NT 4.0, clear the
[Enable banner] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
Printing after resetting the machine
After resetting the remote printer, the
connection from the print server will
be cut off for about 30-40 seconds be-
fore re-connecting. Depending on the
NetWare specification, print jobs may
be accepted, but they will not be
printed during this interval.
When using the machine as a remote
printer, wait about two minutes after
resetting before attempting to print.
106
When the optional IEEE 802.11b
interface unit Is Installed
When using the wireless LAN interface
on the network, note the following:
❖ When moving the machine
Detach the antennas when relocat-
ing the machine locally.
After moving the machine, reat-
tach the antennas, ensuring that:
• The antennas are positioned
clear of obstacles.
• There is 40 to 60 mm between
the antennas, so that they do not
touch.
• The exposure glass cover and the
Auto Document Feeder (ADF)
do not knock the antennas.
❖ If the network area provides poor ra-
dio environment
Where radio wave conditions are
bad, the network may not function
due to interrupted or failed con-
nections. When checking the wire-
less LAN signal and the access
point, follow the procedure below
to improve the situation:
• Position the access point nearer
to the machine.
• Clear the space between access
point and machine of obstruc-
tions.
• Move radio wave generating
applia nc es, such as micro-
waves, away from the machine
and access point.
Note
❒ For information about how to
check radio wave status, see the
General Settings Guide.
❒ For more information about access
point radio wave conditions, refer
to the access point manual.