Ricoh Aficio MP161 Network Manual page 99

Message
Attach to print queue <print queue name>
Authentication mode mismatch< SSID >
btd is disabled.
centrod is disabled.
Cannot create service connection
Cannot find rprinter (<print server
name>/<printer number>)
Change IP address from DHCP Server.
child process exec error! (process name)
Client password rejected
Client tls certificate rejected
Connected DHCP Server(<DHCP server ad-
dress>).
Could not attach to File Server<error number> (In the remote printer mode) Connection to the
Could not attach to P Server<print server>
Current Interface Speed:xxxMbps
Current IP address <currentIP address>
Current IPX address<IPX address>
DHCP lease time expired.
Problem and solutions
(In the print server mode) Attached to the
print queue.
Authentication mode is different to the AP. The
required SSID is the SSID of the access point
connected to when in infrastructure mode.
Communication via Bluetooth is unavailable
because btd is disabled in the security mode.
Enable the btd in the security mode.
Communication via parallel connections una-
vailable because centrod is disabled in the se-
curity mode.
Enable centrod in the security mode.
(In the remote printer mode) Connection to the
file server has not been established. The
number of file server users may have exceeded
the maximum capacity of the file server.
The printer with the number displayed on the
print server does not exist. Make sure that the
printer number is registered on the print server.
The IP address changes when DHCP lease is re-
newed. To always assign the same IP address,
set a static IP address to the DHCP server.
The network service failed to start. Turn the
printer off and then on. If this does not work,
contact your service or sales representative.
The client's password was rejected. Check the
client password.
The client's TLS certificate was rejected. Check
the certificate.
The IP address was successfully received from
the DHCP server.
file server has not been established. The file
server has refused the connection. Check the
file server configuration.
(In the remote printer mode) Connection to the
print server has not been established. The
print server has refused the connection. Check
the print server configuration.
Speed of the network (10Mbps, 100 Mbps, or 1Gbps).
Current IPv4 address.
Current IPX address
DHCP lease time has expired. The printer tries
to discover the DHCP server again. The IP ad-
dress until now becomes invalid.
Message List
2
91