Etherauth; Help; Hostname - Ricoh MP C2800 Operating Instructions Manual

etherauth

Use "Ethernet" command to display or modify the authentication related parameters for Ethernet.
View settings
msh> etherauth
802.1x Configuration
msh> etherauth 8021x {on|off}
• {on} means "active" and {off} means "inactive".

help

Use the "help" command to display the available command list and the procedures for using those
commands.
Command list display
msh> help
Display of procedure for using commands
msh> help "command_name"

hostname

Use the "hostname" command to change the printer name.
View settings
msh> hostname
IPv4 Configuration
msh> hostname "interface_name" "printer_name"
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name beginning "RNP" (in either upper or lower case).
• The Ethernet interface and IEEE 802.11 interface will have the same printer name.
• wlan can be specified only when the IEEE 802.11 interface is installed.
• If you do not specify an interface, the Ethernet interface is selected automatically.
Interface name
ether
wlan
Remote Maintenance by telnet
Interface configured
Ethernet interface
IEEE 802.11 interface
4
175