Disassembly - Epson Stylus Photo R2000s Series Service Manual

EPSON Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series

4.1.7 Disassembly

The flowchart below lists the step-by-step disassembly procedures. When disassembling each unit, refer to the page number shown in the figure.
Start
Front Decoration
Rear Housing
Plate Left/Right
(p.79)
(p.79)
Front Decoration
Plate Left/Right
(p.79)
Decoration Plate
Left/Right (p.82)
Panel Unit (p.80)
Upper Housing /
Printer Cover
(p.83)
Upper Housing
Board Assy (Main
Support Assy
Board/Power Supply
(p.85)
Board) (p.86)
Lower Housing /
Printer Mechanism
(p.98)
ASF Assy (p.108) PF Motor (p.132)
PE Sensor Holder
APG Assy (p.91)
(p.137)
Release Holder Assy
(p.127)
FLAG Release Assy
(p.128)
PE Sensor Holder
(p.137)
Upper Paper
Guide Assys
(p.129)
Disassembly And Assembly
Paper Support Assy
Panel Unit (p.80)
(p.78)
Cover Open Sensor
(p.138)
High Voltage Module
LED Board (p.88)
(p.89)
Waste Ink Pad /
Front Paper Guide
Waste Ink Tube Left/
Pad (p.111)
Right (p.112)
ASF Motor (p.133)
Figure 4-6. Disassembly Flowchart

C H E C K
P O I N T
Stacker Assy

(p.78)

CR Scale (p.92)
APG Assy (p.91) CR Motor (p.131)
Paper EJ Frame
Assy / Front Cover /
CDR Tray Base
PictBridge Holder
Foot (p.113)
Assy (p.113)
Front Paper Guide / Paper
CDR Release Lever
EJ Roller / Front Paper
Sub Assy (p.116)
Guide Pad Tray (p.121)
Ink System Unit
PF Encoder (p.134)
Upper Paper Guide
Assys (p.129)
PF Roller Shaft
(p.124)
Overview
The boxes shown in a dotted-line are not the shortest
procedures, but are necessary to proceed to the next step.
Since a prototype was used to illustrate these disassembly
and assembly procedures, the appearance of some parts
may differ from those on an actual product.
Stylus Photo R1900 was used to illustrate these
disassembly and assembly procedures. The appearance of
some parts differ from those on Stylus Photo R2880,
however, there is no difference in the procedures.
Printhead /
PF Encoder (p.134)
CSIC Assy
(p.94)
CR Scale (p.92)
(p.114)
LED Board (p.88)
APG Assy (p.91)
CDR Sensor (p.136)
Carriage Shaft /
Carriage Unit
(p.118)
(p.100)
Ink Mark Sensor /
PW sensor (p.135)
Revision I
CR Encoder (p.134)
77