Epson Stylus Photo R2000s Series Service Manual page 217

Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series
Note "*1" :When only removing the ASF assy, you do not need to perform the adjustment. In that case, mark the installing positions before removing them, and make sure to align the markings when
installing. See "4.4.6 ASF Assy"
"*2" :Replacing the waste ink tray assy is necessary when resetting waste ink pad counter.
"*3":When only removing the carriage shaft, you do not need to perform the adjustment. In that case, mark on the parallelism adjust bushing (left/right) before removing them, and make sure to
align the markings when installing. See

When the EEPROM data copy cannot be made for the main board that needs to be replaced, the waste ink tray assy must be replaced after replacing
C A U T I O N
the main board with a new one.

After all required adjustments are completed, use the "Final check pattern print" function to print all adjustment patterns for final check. If you find
a problem with the printout patterns, carry out the adjustment again.

When using a new main board for replacing the printer mechanism, the Initial setting must have been made to the main board.

Install the latest Firmware before replace the Printhead. If the installation is not executed, a fatal error may occur. When occur the fatal error, install
the latest Firmware. See
SC-P400 Series
(p.108)
.
"4.4.5 Carriage Shaft / Carriage Unit"
Firmware Update when displays Fatal Error
(p.100)
.
(p.207)
Adjustment
Revision I
217