Epson Stylus Photo R2000s Series Service Manual page 149

EPSON Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series
6. With its conductor connection portion up, set the Adjustment Gauge in the
specified position (on the left side of the Front Paper Guide).

Setting Position
Rear direction: Match the rear end of the Gauge with the Driven Roller Shaft
of the Upper Paper Guide.
Left direction: Release the left end of the Gauge from the Tab on the Front
Paper Guide in
Conductor Connection Point
Tab
Figure 5-6. Setting the Adjustment Gauge
7. Move the Carriage Unit onto the Adjustment Gauge.

Moving position
Match the left end of the Gauge with the left end of the Carriage Unit.
Figure 5-7. Moving the Carriage Unit
Adjustment
Figure 5-6.
Setting Position
Setting Position
8. To set the PG position to the "--" position, turn the PG Cam on the right end of the
Carriage Shaft clockwise so that the point marked "--" faces down.
Figure 5-8. Markings of the PG Cam

PG Standard Value
A D J U S T M E N T
R E Q U I R E D
•
PG – – (Minus Minus) :1.05mm~1.25mm
•
PG – (Minus)

Adjustment Resolution
Adjustment
Revision I
PG Cam
:1.2mm~1.4mm
:
0.06mm
149