Epson Stylus Photo R2000s Series Service Manual page 115

EPSON Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series
9. Remove the C.B.S. M3 x 6 screw that secures the Right CDR Tray Base Support,
and remove the Right CDR Tray Base Support.
Figure 4-108. Remove the CDR Tray Base Support
10. Remove the E Ring that secures the CDR Tray Base and remove the CDR Tray
Base in the direction of the arrow.
CDR Tray Base
Figure 4-109. Remove the CDR Tray Base
Disassembly And Assembly
Right CDR Tray Base Support
2) C.B.S. M3x6
E Ring
Disassembling the Printer Mechanism

Hook both rear ends of the Paper EJ Frame Assy onto the tabs
on the Main Frame.

Align the bearing of the CDR Release Level Sub Assy with the
Paper EJ Release Shaft.
Shaft and
Bushing
Figure 4-110. Reinstalling the Paper EJ Frame Assy

Attach the LABEL,CAUTION,CDR;B (parts code:1470311) at
the position as shown below.
34mm
LABEL,CAUTION,CDR;B
Figure 4-111. Attaching Position of the CDR Caution Label

Match the tabs with the five positioning holes.
See Figure 4-106.

Tighten the screws in the order shown in
A D J U S T M E N T
After replacing or removing the Paper EJ Frame Assy, always make
R E Q U I R E D
the required adjustments referring to the following.
• "Chapter 5
Adjustment
Revision I
Shaft and
Bushing
Tabs
2mm
Figure 4-107
(p.139)"
115