Epson Stylus Photo R2000s Series Service Manual page 109

EPSON Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series
Referring to Figure 4-93, correctly route each of the cables and
FFCs.
C H E C K
When only removing the ASF Assy, you do not need to perform
P O I N T
"5.2.5 ASF Guide Roller LDs Position Adjustment
case, mark the installing positions of the Guide Roller LDs before
removing them, and make sure to align the markings when
installing the Guide Roller LDs.
Figure 4-94. Marking Position
9. Remove the two C.B.S. M3 x 6 screws that secure the two Guide Roller LDs.
10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the Guide
Roller LDs.
Guide Roller LD
LD Roller Shaft
Figure 4-95. Removing the Guide Roller LD
Disassembly And Assembly
11. Remove the three C.B.S. (P4) M3 x 8 screws that secure the ASF Assy, and
(p161)". In that
1
Front 2) C.B.S. M3x6
Face (8±1 kgf.cm)
Tab
Guide pin
Guide Roller LD
Disassembling the Printer Mechanism
Align the guide pins and tabs on the Guide Roller LDs with the
positioning holes on the Main Frame.
remove the ASF Assy from the Printer Mechanism.
ASF Assy
6) C.B.S. (P4) M3x8
(6±1 kgf.cm)
2
Figure 4-96. Removing the ASF Assy
Revision I
(Refer to Figure 4-95.)
6) C.B.S. (P4) M3x8
(6±1 kgf.cm)
34
109