Epson Stylus Photo R2000s Series Service Manual page 228

Stylus Photo R1900/R2880/R2000/R2000s/SC-P400 Series
Measurement start point
Figure 9-18. Starting the Color Measurement
SC-P400 Series
Table 9-12. Troubleshooting when the measurement fails
Presumable Cause
The adjustment of the printer may
be insufficient.

The media has deteriorated and
discolored.

The media was stored in bad
conditions and damaged.
The color or contamination of the
backing may be interfering.
Wrong row/wrong measuring
direction
Measuring at an angle
Adjustment
Major Troubleshooting
After the adjustments that must be done after parts
replacement are all complete, perform the
measurement again.
Use new Ultra Premium Presentation Paper Matte
Enhanced Matte Paper or Archival Matte Paper.

When using the backing board: remove any
contamination on the backing board, and then stack
two color charts over on each other and perform the
measurement.

Measurement without a backing board: Stack the
color chart over on each other on blank (white)
Premium Glossy Photo Paper and perform the
measurement.
See Figure 9-16 and Table 9-11 and confirm the
current row to be measured and the measuring
direction are correct.
Align the scale with the chart correctly again, and then
slide the calibrator in parallel to the row to be
measured on the patches.
Revision I
228