Panasonic KX-NS700 Feature Manual page 440

21.1.5 Voice Mail DTMF Integration
Pressing the
MESSAGE
button
4.
AA Service
If the VPS transfers the call using the AA service, the PBX will inform the VPS of the status of the
called destination with the preprogrammed DTMF status signal so that the VPS can confirm the status
of the extension without listening to the system tones (e.g., ringback tone).
Assign the DTMF status signal to suit the VPS settings.
[DTMF Status Signals and Conditions]
Status
RBT (ringback tone)
BT (busy tone)
ROT (reorder tone)
DND (DND tone)
Answer
FWD VM RBT (FWD to
Voice Mail ringback
tone)
FWD VM BT (FWD to
Voice Mail busy tone)
FWD EXT RBT (FWD
to extension ringback
tone)
Confirm (confirmation
tone)
Disconnect
11.12.1 PBX Configuration—[3-12-1] Group—VM(DTMF) Group—System Settings
→ VM DTMF Status Signal—Ringback Tone
→ VM DTMF Status Signal—Busy Tone
→ VM DTMF Status Signal—Reorder Tone
→ VM DTMF Status Signal—DND Tone
→ VM DTMF Status Signal—Answer
→ VM DTMF Status Signal—Confirm
→ VM DTMF Status Signal—Disconnected
440 Feature Manual
PBX
Extn. 102
The PBX is ringing the corresponding extension.
The called extension is busy.
The dialed number is invalid.
The called extension has set DND. (→ 5.1.13 DND
(Do Not Disturb))
The called extension has answered the call.
The called extension has set FWD to VPS and the
PBX is calling another port of the VPS.
The called extension has set FWD to VPS and all
ports of the VPS are busy.
The PBX is calling an extension other than the one
dialed. FWD or Idle Extension Hunting (→
10.1.10 Idle Extension Hunting) may be assigned
by the called extension.
The PBX receives confirmation that the feature has
been successfully set or canceled (e.g., Message
Waiting) on the extension.
The caller has hung up.
Sent "#6" + " ", "102".
Switching to VM command
VPS (In AA
service mode)
Mailbox for
Extn. 102
Condition
Listening message
command, mailbox number
Default Command
Document Version 2017-06
1
2
3
4
5
6
7
8
9
#9