7.1.6 FOS Interface
13.3.2 PBX Configuration—[5-3-2] Optional Device—Voice Message—DISA Message—Floating Extension
Number
PT Programming Manual References
[623] Incoming Call Distribution Group Name
[660] UM Group Floating Extension Number
[700] External Pager Floating Extension Number
[730] Outgoing Message (OGM) Floating Extension Number
[731] Outgoing Message (OGM) Name
[811] Modem Floating Extension Number
[812] ISDN Remote Floating Extension Number
Feature Manual References
15.1.4 PC Programming
20.1.1 UNIFIED MESSAGING FEATURES
21.1.3 Voice Mail (VM) Group
7.1.6 FOS Interface
Description
You can connect a FOS system (Front Office Software) for use in hotels directly to the PBX.
Conditions
•
KX-NSF101 (CTI interface) or KX-NSA020 (CSTA Multiplexer) is required to use this feature.
•
This feature cannot be used if this PBX is a member of a One-look network.
•
The built-in FOS interface supports the following commands:
FOS → PBX
–
Link Alive
–
Link Start
–
Check In/Check Out
–
Message Waiting On/Off
–
Do Not Disturb Set/Clear
–
Wakeup Time Set/Clear
–
Change COS
–
Room Sharing/Guest Change
–
Post Answer
–
Room Change
Note
When the built-in UM is used on the One look network, the built-in UM of the master unit will be the
target of Room Change.
Accordingly, all the extensions (including extensions installed to the slave units) must use the built-
in UM of the master unit.
PBX → FOS
–
Link Alive
–
Link Start
144
Feature Manual
Document Version 2017-06