Ricoh R-C4 Service Manual page 82

21 July 2006
5. Connect the HDD harness [A] (
6. Connect the AC harness [B] (
x1)
NOTE: Close the harness clamp
around both cables.
7. Reinstall the controller board.
After Installing the HDD
1. Do SP5853 to copy the preset stamp
data from the firmware to the hard disk.
Then turn the main power switch off/on.
2. It is not necessary to format the new
hard disk after installation.
INSTALLATION REQUIREMENTS
x2).
[B]
x2,
1-69
[A]
B767I106.WMF