Ricoh R-C4 Service Manual page 425

21 July 2006
APPENDIX 1 (FOR MODEL R-C4/R-C4.5)
1. RSS (REMOTE SERVICE SYSTEM)
1.1 RSS SET UP
[B]
[A]
[H]
CAUTION
Unplug the machine power cord before starting the following procedure.
1. Remove the connector cover [A] (1 clip) and disconnect the cable.
2. Remove the rear cover [B] (4 screws).
3. Remove the duplex connector cover [C] (1 screw) and the lower rear cover [D]
(2 screws).
4. Install the RSS board [E] to the bracket [F] (4 screws).
5. Install the RSS board assembly to the machine (2 screws).
6. Install the harness [G] between the RSS board and the IPU board (CN107).
When connecting only one machine to the line adapter, skip step 7.
7. Set the jumper switch [H] on the RSS board as shown (default setting: 1-2).
8. Remove the cover [I] from the lower rear cover.
B027R515.WMF
B027I305.WMF
APPENDIX-1
[C]
[D]
[F]
[E]
RSS SET UP
B027R705.WMF
[G]
B089I900.WMF
[I]