Ricoh R-C4 Service Manual page 246

SERVICE PROGRAM MODE
5844 USB
5844 1 Transfer Rate
Sets the speed for USB data transmission.
[Full Speed]
[Auto Change]
5844 2 Vendor ID
Sets the vendor ID:
Initial Setting: 0x05A Ricoh Company
[0x0000~0xFFFF/1] DFU
5844 3 Product ID
Sets the product ID.
[0x0000~0xFFFF/1] DFU
5844 4 Device Release No.
Sets the device release number of the BCD (binary coded decimal) display.
[0000~9999/1] DFU
Enter as a decimal number. NCS converts the number to hexadecimal number
recognized as the BCD.
5845 Delivery Server Setting
These are delivery server settings.
5845 1 FTP Port No.
[0~65535/1]
5845 2 IP Address (Primary)
Use this SP to set the Scan Router Server address. The IP address under the
transfer tab can be used with the initial system setting.
[0~FFFFFFFF/1]
5845 5 Capture Server IP Address
Sets the IP address that is assigned to the PC that the capture server (eCabinet
or ScanRouter) operates. This IP address is set remotely when the delivery
server (Scan Router) IO device is registered. This SP only enables the IP
address permit access to the DNS browser names.
5845 6 Delivery Error Display Time
Use this setting to set the length of time that the message is shown when a test
error occurs during document transfer with the NetFile application and an
external device.
[0~999/1]
5845 8 IP Address (Secondary)
Sets the IP address that is given to the computer that is the secondary delivery
server for Scan Router. This SP lets you set only the IP address, and does not
refer to the DNS setting.
5-58
21 July 2006