Table of Contents
Advertisement
21 July 2006
5912*
PCU Alarm Setting
5912 2
Interval Display
5913
Switchover Permission Time
5913 2
Print Application Timer
Sets the length of time to elapse before allowing another application to take
control of the display when the application currently controlling the display is not
operating because a key has not been pressed.
[3~30/1 s]
5913 102 Print Application Set
This SP prescribes the time interval to expire before the machine shifts to
another application when another application currently holds access control for
the standby mode while there is no key input.
[0~1/1/1]
5915*
Mechanical Counter Detection
Checks whether the mechanical counter inside the inner cover is connected or not.
Display:
0:Not detected
1:Detected
2:Unknown
5921*
Exhaust Fan Control
Sets the timing for slowing the exhaust fan motor speed or shutting the motor off for
normal operation, depending on the following conditions:
1. After the machine has entered energy saver mode or stand-by mode, the
machine slows the fan speed after this time runs out.
2. After the machine has entered the auto off mode or an error occurs, the machine
stops the fan after this time runs out.
[30 ~ 120 / 30 s / 1 s]
5923*
Border Remove Area Switching
Toggles between two settings that affect the appearance of the pages for border
removal and printed facing pages: (1) Using the original area as the allotted area,
or (2) Using only the copy paper as the allotted area.
[0 = Original base, 1 = Copy base]
0: Original area used as base
1: Copy used as the base
Sets the PCU alarm interval. When the machine reaches this
value, the PCU alarm will be displayed on the LCD to inform the
user.
[0 ~ 255 / 60 / 1 k copies/step]
Note: The zero setting switches the alarm off.
5-71
SERVICE PROGRAM MODE
Advertisement
Table of Contents
Troubleshooting
