Ricoh R-C4 Service Manual page 253

21 July 2006
5850* Address Book Function
5850 3 Replacement of Circuit Classification
The machine is shipped ready to use with a G3 line. Use this SP to switch all at
once to G4 after adding a G4 line. If the G4 line becomes unusable for some
reason, you can use this SP to switch easily back to G3
Bit
1 G3
2 Internal
3 G3-1
4 G3-1 Internal
5 G3-2
6 G3-2 Internal
7 G3-3
5849 Installation Date
Displays or prints the installation date of the machine.
5849 1 Display
5849 2 Switch to Print
5851 Bluetooth Mode
Sets the operation mode for the Bluetooth Unit. Press either key.
[0:Public] [1: Private]
5853 Stamp Data Download
Push [Execute] to download the fixed stamp data from the machine ROM onto the
hard disk. Then these stamps can be used by the system. If this is not done, the
user will not have access to the fixed stamps ("Confidential", "Secret", etc.).
You must always execute this SP after replacing the HDD or after formatting the
HDD. Always switch the machine off and on after executing this SP.
5856 Remote ROM Update
When set to "1" allows reception of firmware data via the local port (IEEE 1284)
during a remote ROM update. This setting is reset to zero after the machine is
cycled off and on. Allows the technician to upgrade the firmware using a parallel
cable
[0~1/1]
0: Not allowed
1: Allowed
The "Counter Clear Day" has been changed to "Installation
Date" or "Inst. Date".
Determines whether the installation date is printed on the
printout for the total counter.
[0~1/1]
0: No Print
1: Print
5-65
SERVICE PROGRAM MODE
Bit
8 G3-3 Internal
9 G3 Open Line
10 Internal Open Line
11 I-G3
12 I-G3 Internal
13 G4