Table of Contents
Advertisement
12.47
Removing the engine guard (EXC‑F AU, EXC‑F Six Days)
12.48
Installing the engine guard (EXC‑F AU, EXC‑F Six Days)
–
Fill bleeding syringe
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap,
remove bleeder screw
S01327-10
–
Inject the liquid into the system until it escapes from open-
6
ings
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws
bleeder screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
E00339-10
rim
–
Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Remove screws
H01638-10
–
Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H01638-10
SERVICE WORK ON THE CHASSIS 12
4
with the appropriate hydraulic fluid.
p. 159)
5
and mount bleeding syringe
4 mm (0.16 in)
1
and engine guard.
1
.
M6
10 Nm (7.4 lbf ft)
4
.
95
Advertisement
Table of Contents
