Changing The Hydraulic Clutch Fluid; Removing The Engine Guard (Exc-F Aus, Exc-F Six Days); Installing The Engine Guard (Exc-F Aus, Exc-Fsix Days) - KTM 350 EXC-F EU 2013 Owner's Manual

Hide thumbs Also See for 350 EXC-F EU 2013:
Table of Contents

Advertisement

11
SERVICE WORK ON THE CHASSIS
11.48

Changing the hydraulic clutch fluid

Warning
Environmental hazard Hazardous substances cause environmental damage.
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
11.49
Removing the engine guard (EXC‑F AUS, EXC-F SIX DAYS)
11.50
Installing the engine guard (EXC‑F AUS, EXC-F SIX DAYS)
x
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
Remove screws
Remove cover
101365-10
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
On the slave cylinder of the clutch, remove bleeder screw
syringe
4
101366-10
Inject the liquid into the system until it escapes from openings
cylinder without bubbles.
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
Position the cover with the membrane. Mount and tighten the screws.
101367-10
Turn quick release
guard.
101368-10
Attach the engine guard on the frame at the rear and swing up at the front.
Turn quick release
101369-10
.
1
with membrane
.
2
3
with the appropriate hydraulic fluid.
4
p. 114)
.
counterclockwise until it disengages. Remove the engine
1
clockwise all the way.
1
and mount bleeding
5
of the master
6
4 mm (0.16 in)
68

Advertisement

Table of Contents
loading

Table of Contents