18.2
Checking the engine oil level
18.3
Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Drain engine oil with engine at operating temperature.
–
Start the engine and check the response.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
Condition
The engine is at operating temperature.
–
Check the engine oil level.
Info
After switching off the engine, wait one minute
before checking the level.
The engine oil is at a level between the lower edge
K00578-10
and the middle of the level viewer
»
If the engine oil is not up to the lower edge
level viewer:
–
Add engine oil. (
Preparatory work
(EXC‑F AU, EXC‑F Six Days)
–
Remove the engine guard. (
–
Park the motorcycle on a level surface.
Main work
–
Place a suitable container under the engine.
–
Remove oil drain plug
Info
Do not remove screws
K00567-10
SERVICE WORK ON THE ENGINE 18
B
.
p. 139)
p. 95)
1
with the magnet and seal ring.
2
.
A
A
of the
137