Removing The Engine Guard (Exc-F Six Days, Exc-F Au); Installing The Engine Guard (Exc-F Six Days, Exc-F Au) - KTM 450 EXC-F 2019 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.47
12.48
94
H01697-10
E00339-10
Removing the engine guard (EXC‑F Six Days, EXC‑F AU)
H01638-10
Installing the engine guard (EXC‑F Six Days, EXC‑F AU)
H01638-10
–
4
Fill bleeding syringe with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap,
5
remove bleeder screw
–
Inject the liquid into the system until it escapes from open-
6
ings of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws
bleeder screw. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
–
Position cover with membrane. Mount and tighten screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Remove screws 1 and engine guard.
–
Attach the engine guard on the frame at the rear and swing up
at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
p. 155)
and mount bleeding syringe
4 mm (0.16 in)
1
.
M6 10 Nm (7.4 lbf ft)
4
.