Table of Contents
Advertisement
12.11
Installing the lower triple clamp
(EXC‑F EU/AU/AR/BR)
Main work
–
Clean the bearing and sealing elements, check for damage,
and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the
upper steering head bearing.
–
Check whether upper steering head seal
tioned.
–
Slide on protective ring
B01605-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Secure wiring harness and clutch line with cable holder.
–
Position the voltage regulator, and mount and tighten
5
screws
.
Guideline
Remaining screws,
chassis
K00548-11
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the top edge of the upper triple clamp.
H01672-10
–
Tighten screws
Guideline
Screw, bottom triple
clamp
V00464-10
SERVICE WORK ON THE CHASSIS 12
p. 161)
1
2
3
and O-ring
4
but do not tighten yet.
M6
6
are positioned toward the front.
7
.
M8
is correctly posi-
.
10 Nm (7.4 lbf ft)
15 Nm (11.1 lbf ft)
69
Advertisement
Table of Contents
