Table of Contents
Advertisement
12.40
Checking the frame
12.41
Checking the swingarm
12.42
Checking throttle cable routing
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining screws,
chassis
Remaining nuts,
chassis
E00333-01
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the frame for cracking and deformation.
»
If the frame exhibits cracking or deformation due to a
mechanical impact:
–
Change the frame.
S01316-10
–
Check the swingarm for damage, cracking, and deformation.
»
If the swingarm shows signs of damage, cracking, or defor-
mation:
–
Change the swingarm.
S01317-10
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank.
SERVICE WORK ON THE CHASSIS 12
M6
M6
Info
Always replace a frame that has been dam-
aged due to a mechanical impact. Repair of the
frame is not authorized by KTM.
Info
Always change a damaged swingarm. Repair of
the swingarm is not authorized by KTM.
p. 77)
(
p. 83)
10 Nm
(7.4 lbf ft)
10 Nm
(7.4 lbf ft)
p. 63)
91
Advertisement
Table of Contents
