12.9
Removing the lower triple clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and
tighten screws
K00546-10
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
(EXC‑F EU/AU/AR/BR)
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove front fender. (
–
Remove the handlebar cushion.
Main work
–
Open the cable holder in front of the right radiator and detach
the wiring harness.
–
Remove screws
–
Open the cable holder in front of the left radiator and detach
the wiring harness.
–
Loosen screw
–
Remove screw
E00380-10
–
Take off the upper triple clamp with the handlebar and set it
aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
E00381-10
SERVICE WORK ON THE CHASSIS 12
M8
25 Nm (18.4 lbf ft)
5
.
(
p. 108)
p. 122)
(
p. 107)
(
p. 65)
p. 75)
1
and hang the voltage regulator to the side.
2
.
3
.
4
5
and protective ring
.
4
.
Loctite
®
243™
p. 121)
p. 121)
p. 63)
67