15 ELECTRICAL SYSTEM
15.12
124
E00360-10
Changing the combination instrument
V00370-10
V00371-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully take off diffuser
–
Lightly squeeze orange cap
and take it off.
–
Press the turn signal bulb lightly into the socket, turn it coun-
terclockwise by about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers and keep it
free from grease.
–
Press the new turn signal bulb carefully into the socket and
turn it clockwise until it stops.
Turn signal (R10W / socket BA15s) (
–
Mount the orange cap.
–
Position the diffuser.
–
Insert the screw and first turn counterclockwise until it
engages in the thread with a small jerk. Tighten the screw
lightly.
Finishing work
–
Check that the turn signal system is functioning properly.
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
–
1
Remove screws
with the washers.
–
Pull the combination instrument upward out of the holder.
–
Using a coin, turn protection cap
wise and remove it.
–
Remove combination instrument
–
Insert the combination instrument with the label facing
upward.
Combination instrument battery (CR 2430) (
–
Check the O-ring of the protection cap for correct seating.
1
.
2
in the area of the holding lugs
p. 154)
p. 121)
2
all the way counterclock-
3
.
p. 154)