Buell P3 2003 Service Manual page 92

HOME
INSTALLATION
1. Place wheel centrally in the swingarm. Slide wheel far
enough forward to slip belt over sprocket and rest belt on
sprocket inboard of the teeth.
NOTE
Do not place belt on sprocket teeth at this time. Alignment of
parts will be difficult. Resting belt next to teeth allows slack for
easier alignment of wheel assembly.
7705
2
1
1. Axle
2. Rear axle hole
Figure 2-10. Rear Axle, Left Side
2. See Figure 2-10. Hold left side spacer in place and slide
caliper and carrier over rotor.
7701
6
5
4
1. Axle
2. Axle nut (metric)
3. Lockwasher
4. Washer
5. Spacer
6. Sprocket bolts (5)
7. Sprocket cover
Figure 2-11. Rear Axle, Right Side
3. Slide axle through washer, swing arm, carrier, left side
spacer and wheel assembly.
a. See Figure 2-11. Hold right side spacer in place.
b. Insert axle through right side spacer and swingarm.
c. Install flat washer, lockwasher and axle nut.
4. Place screwdriver or rod through axle hole and torque
rear axle nut to 48-52 ft-lbs (65-71 Nm).
5. Slide belt on sprocket teeth by rotating wheel to "walk"
belt onto teeth.
6. Lower motorcycle rear wheel.
7
1
2
3
2003 Buell P3: Chassis 2-13