HOME
REMOVAL - REAR FRAME
ASSEMBLY
1.
Remove tail section.
2.
Disconnect rear wire harness connector [7] (6-place
amp), located under seat near fuse block. Detach con-
nector from "T" stud.
3.
See
Figure 2-110.
Remove fasteners (13) and bracket
(12).
4.
Remove fasteners (11).
5.
Slide rear frame assembly (10) out.
INSTALLATION - REAR FRAME
ASSEMBLY
1.
Slide rear frame assembly (10) into frame.
2.
Install fasteners (11).
3.
Install brackets (12) and fasteners (13).
4.
Connect rear wire harness and mount on "T" stud.
INSTALLATION - TAIL SECTION
1.
Install license plate bracket (5) using fasteners (4) and
nuts (9) in rear holes.
2.
Install taillight using flat washers and nuts.
3.
Install turn signals (6) using lock washers (7) and nuts
(8).
4.
Connect turn signal wires and taillight wires. Cable tie
together.
5.
Install tail section (1) using fasteners (3, 19, 20).
6.
Connect battery negative cable.
11
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation, causing loss of control of vehi-
cle and death or serious injury.
7.
Install seat. See
2.28 SEAT.
WARNING
2003 Buell P3: Chassis
2-65