Buell P3 2003 Service Manual page 359

HOME
INSTALLATION
1. With the lipped side facing inboard, install new camshaft
oil seal into gearcase cover, if removed. Press seal into
position until lightly bottomed.
2. Install rotor cup.
a. Apply LOCTITE THREADLOCKER 243 (blue) to
threads of screw.
b. Position rotor cup onto end of camshaft aligning
notch with camshaft slot.
c. Install screw to secure rotor cup. Tighten screw to
43-53 in-lbs (5-6 Nm).
3. Install module plate with two screws.
4. See Table 7-15. Install ignition module wiring terminals
into correct positions in plug end of connector [10]. See
Wiring Diagram. Install pin terminals. See
ELECTRICAL CONNECTORS.
5. See Figure 7-17. Mate connector [10] and install to T-
stud on frame backbone.
6. Install locknut to clamp that secures hoses and wire har-
ness on right side of motorcycle.
7. Install module plate with two screws. Do not tighten
screws.
8. Install negative battery cable to battery terminal. Tighten
fastener to 60-96 in-lbs (7-11 Nm).
9. Check ignition timing. See
10. Tighten module plate screws to 10-20 in-lbs (1-2 Nm).
11. Install new outer timer cover.
7-20 2003 Buell P3: Electrical
B.2 DEUTSCH
IGNITION TIMING.
a0288x7x
Figure 7-20. Ignition Connector [10]
Table 7-15. Ignition Module Connector [10]
CHAMBER
WIRE COLOR
NUMBER
1 White/Black
2 Violet/White
3 Violet/Orange
4 Pink
*Lt Green/Grey
5 [10A]
*Tan/Yellow [10B]
6 Black
FUNCTION
To Ignition Switch
To TP Sensor
To Auto-Enrichener
To Coil
To Sidestand Interlock
Ground