Buell P3 2003 Service Manual page 411

HOME
4
a0225x7x
3
1. Connector [88]
2. Throttle position sensor
3. Tamper-resistant T20 TORX screws
4. Auto-enrichener
Figure 7-98. TP Sensor/Auto-Enrichener Connector [88]
16. See Figure 7-98. Mate TP sensor/auto-enrichener con-
nector [88] and secure with cable strap.
17. Install connector [83] to coil and secure with cable strap.
18. See Figure 7-92. Mate ignition module connector [10]
and attach to T-stud on left side of frame backbone.
19. Feed longer bundle at front through frame hole to left
side of motorcycle. Attach harness to T-stud.
20. Hook right side of harness to two T-studs on right side of
motorcycle.
21. Mate right handlebar switch connector [22], front brake
lamp switch connector [170]. Secure wires with cable
straps.
22. Mate left handlebar switch connector [24] and clutch
switch connector [95]. Secure wires with cable straps.
23. Connect speedometer connector [39].
24. Mate ignition switch connector [33].
25. Install left and right front turn signal bullet connectors as
marked during removal.
7-72 2003 Buell P3: Electrical
1
2
7816
BK
Y/BK
Figure 7-99. Horn Connector [122]
26. See Figure 7-99. Feed horn wires through frame hole on
right side and install connector [122] to horn. Cable strap
wires to isolator mount.
27. Cable strap main wiring harness to frame backbone with
three cable straps.
28. Connect headlamp connector [38] and install headlamp
housing. See 7.17 HEADLAMP.
29. Install windscreen with four screws and washers. See
2.26 WINDSCREEN.
30. Install fuel tank. 4.2 FUEL TANK COVER/FUEL
11 1
WARNING
Always connect the positive battery cable first. If the pos-
itive cable should contact ground with the negative cable
installed, the resulting sparks could cause a battery
explosion which could result in serious injury or death.
31. Install battery and reconnect battery cables, positive
cable first. See 7.16 BATTERY.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
32. Install seat. See 2.28 SEAT.
11 1
WARNING
Check for proper tail lamp, turn signal and headlamp
operation before riding motorcycle. Visibility is a major
concern for motorcyclists. Failure to have proper tail
lamp, turn signal and/or headlamp operation could result
in death or serious injury.
33. Check for proper operation of headlamp, turn signals,
brake lamp and starting, charging and ignition systems.
TANK.
WARNING
WARNING
WARNING