Buell P3 2003 Service Manual page 389

HOME
Headlamp
1
CAUTION
The headlamp contains Halogen gas under pressure.
Handle headlamp careful and wear eye protection. If the
headlamp is mishandled or dropped, it could explode
which could result in mild or moderate injury.
1. See Figure 7-63. Connect headlamp connector to rear of
headlamp.
NOTE
Align protrusion "A" on headlamp with slot in upper portion of
nest for proper fit. Retaining ring only fits one way. Rotate
retaining ring until all three holes align.
2. Install headlamp and retaining ring to nest with three phil-
lips screws. Tighten screws to 12-14 in-lbs (1-2 Nm).
NOTE
Make sure slots on bezel are positioned so they allow access
to adjusting screws.
3. Install bezel to retaining ring with three phillips screws.
Tighten screws to 12-14 in-lbs (1-2 Nm).
4. Install windscreen with four screws and washers. See
2.26 WINDSCREEN.
11 1
WARNING
Check for proper headlamp operation before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Failure to have proper headlamp operation could
result in death or serious injury.
7-50 2003 Buell P3: Electrical
WARNING
a0252x7x
1
1. Headlamp switch
2. Headlamp high beam
3. Headlamp low beam
Figure 7-64. Headlamp Switch
5. See Figure 7-64. Check headlamp for proper operation.
a. Turn ignition key switch to IGN.
b. Check headlamp LOW and HIGH beam settings.
c. Set headlamp to LOW beam. Press passing lamp
switch. Headlamp should flash HIGH beam for as
long as the switch is pressed.
d. Turn ignition key switch to OFF.
e. If operation fails, reread procedure and verify that all
steps were performed.
6. Align headlamp. See 1.22 HEADLAMP.
2
3