Buell P3 2003 Service Manual page 49

HOME
8. Adjust as follows:
a. See Figure 1-14. Pull ferrule (end of cable housing)
away from bracket. Gap between ferrule and bracket
should be 0.0625-0.125 in. (1.6-3.2 mm).
b. See Figure 1-12. Set freeplay by turning adjuster.
c. Tighten jam nut against adjuster.
d. Slide rubber boot over cable adjuster mechanism.
9. Change or add transmission fluid if necessary.
NOTE
Clean parts before re-assembly and use a new gasket.
10. See Figure 1-13. Install clutch inspection cover using
three TORX screws with washers. Tighten in a crosswise
pattern to 7-9 ft-lbs (9.5-12.2 Nm).
11. Check clutch cable freeplay. See Step 6 above.
12. Install left footpeg support bracket. See
PEGS AND FOOTPEG SUPPORT BRACKETS.
1-18 2003 Buell P3: Maintenance
a0158x6x
1
1. Ferrule
2. Bracket
Figure 1-14. Adjusting Clutch Freeplay
2.21 FOOT-
2