Buell P3 2003 Service Manual page 177

HOME
a0162x6x
7
6
5
4
1. Frame
2. Locknut
3. Snubber
4. Bolt
5. Spacer
6. Front isolator
7. Standoff
Figure 3-41. Front Isolator Mount
32. See Figure 3-41. Install front isolator mounting bolt,
spacer snubber and new nut.
33. Tighten front isolator mounting bolt to 63-70 ft-lbs (86-95
Nm).
7629
Figure 3-42. Install Crankcase Breather Hose
34. See Figure 3-42. Install crankcase breather hose and
crankcase breather into rocker box grommet.
35. Install horn. See 7.22 HORN.
36. Remove jack from under the motor.
37. Install muffler. See 2.20 EXHAUST
38. Install fuel tank. See
TANK.
39. Install new oil filter, engine oil and primary chaincase
fluid as necessary.
1
3 2
SYSTEM.
4.2 FUEL TANK COVER/FUEL
a0016x3x
1
2
3
4
5
6
1. Frame
2. Locknut
3. Washer
4. Spacer
5. Footrest support bracket
6. Clevis pin
7. Footpeg
8. Cotter pin
9. Index plate
10. Spacer
Figure 3-43. Footpeg Bracket Assembly
40. See Figure 3-43. Install right side rider footpeg bracket
assembly. See 2.21 FOOTPEGS AND FOOTPEG SUP-
PORT BRACKETS.
11 1
WARNING
Always connect positive battery cable first. If the positive
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
sion which could result in death or serious injury.
41. Connect both battery cables, positive cable first. See
7.16 BATTERY.
11 1
WARNING
Pull up on seat to verify that it is properly secured, front
and rear. A loose seat may shift during vehicle operation
and startle the rider, possibly causing loss of vehicle
control resulting in death or serious injury.
42. Install seat. See 2.28 SEAT.
10
9
8
7
WARNING
WARNING
2003 Buell P3: Engine 3-23