Buell P3 2003 Service Manual page 141

HOME
REAR FENDER REMOVAL
1. Remove seat. See 2.28
2. Remove right side footpeg support. See
PEGS AND FOOTPEG SUPPORT
a0012xSx
2
1
1. Screws, rear fender mounting (4)
2. Washers (4)
3. Well nuts (4)
4. Clamp, rear brake line
5. Fender, rear
Figure 2-108. Rear Fender Assembly
3. See Figure 2-108. Remove rear fender mounting screws
and washers from rear fender.
4. Remove rear fender.
2-62 2003 Buell P3: Chassis
SEAT.
2.21 FOOT-
BRACKETS.
5
4
3
REAR FENDER INSTALLATION
1. Position rear fender.
2. Install rear fender mounting screws, washers and well-
nuts on rear fender.
3. Tighten rear fender mounting screws to 30-36 in-lbs (3-
4 Nm).
4. Install right side footrest support bracket. See
FOOTPEGS AND FOOTPEG SUPPORT BRACKETS.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation, causing loss of control of vehi-
cle and death or serious injury.
5. Install seat. See 2.28 SEAT.
WARNING
2.21