Wheels - Buell P3 2003 Service Manual

HOME

WHEELS

GENERAL
Good handling and maximum tire mileage are directly related
to the care of wheels and tires. Regularly inspect wheels and
tires for damage and wear. If handling problems occur, see
Table 2-6.
Keep tires inflated to the recommended air pressure. Always
balance the wheel after replacing a tire.
11 1
WARNING
Do not inflate any tire beyond its maximum inflation pres-
sure as specified on tire sidewall. Overinflation may lead
to premature tire failure which could result in death or
serious injury.
TROUBLESHOOTING
See Figure 2-2. Check tire inflation pressure at least once
each week. At the same time, inspect tire tread for punctures,
cuts, breaks and other damage. Repeat the inspection before
long trips.
CHECK FOR
Loose axle nuts.
Excessive side-play or radial (up-and-down)
play in wheel hubs.
Alignment of rear wheel in frame or with
front wheel.
Rims and tires out-of-true sideways; should
not be more than 0.080 in. (2.03 mm).
Rims and tires out-of-round or eccentric
with hub; should not be more than 0.090 in.
(2.29 mm).
Irregular or peaked front tire wear.
Correct tire inflation.
Correct tire and wheel balance.
Steering head bearings.
Damper tubes.
Shock absorber.
Swingarm bearings.
2-6 2003 Buell P3: Chassis
WARNING
Table 2-6. Wheel Service
Apply LOCTITE THREADLOCKER 243 (Blue) and tighten front axle nut
(metric) to 38-42 ft-lbs (52-57 Nm).
Tighten rear axle nut (metric) to 48-52 ft-lbs (65-71 Nm).
Replace wheel hub bearings.
Repair swingarm as described under
Replace rims. See
Replace rims. See
Replace as described under
Inflate tires to correct pressure. See
Static balance may be satisfactory if dynamic balancing facilities are not
available. However, dynamic balancing is strongly recommended.
Correct adjustment and replace pitted or worn bearings. See
STEM AND BRACKET
Check for leaks. See
Check damping action and mounts. See
Check for looseness. See
a0198x2x
Figure 2-2. Checking Tire Inflation Pressure
REMEDY
2.19 SWINGARM.
2.9 TIRES.
2.9 TIRES.
2.5 FRONT WHEEL
2.2 TIRE SPECIFICATIONS.
ASSEMBLY.
2.17 FRONT FORK.
2.15 REAR SHOCK
2.19 SWINGARM.
2.4
or 2.9 TIRES.
2.18 FORK
ABSORBER.