Buell P3 2003 Service Manual page 113

HOME
CLEANING AND INSPECTION
11 1
WARNING
Clean brake system components using denatured alco-
hol. Do not use mineral-base cleaning solvents, such as
gasoline or paint thinner. Use of mineral-base solvents
causes deterioration of rubber parts that continues after
assembly. This could result in improper brake operation
which could result in death or serious injury.
1. Thoroughly clean master cylinder and all brake system
components. Stand master cylinder on wooden block or
towel to protect seating surfaces.
a. Examine walls of master cylinder reservoir for
scratches and grooves. Replace if damaged.
b. Verify that vent holes on master cylinder are com-
pletely open and free of dirt or debris.
2. Inspect boot on front of master cylinder for cuts, tears or
general deterioration. Replace if necessary.
2-34 2003 Buell P3: Chassis
WARNING
ASSEMBLY
1. See Figure 2-50. Insert piston assembly (4), spring first,
into master cylinder.
6506
1. Master cylinder body
2. Snap ring
3. Rod assembly
4. Piston assembly
Figure 2-50. Master Cylinder Internals
2. Place round side of rod assembly (3) over piston.
Depress piston into master cylinder body (1) and secure
with a new snap ring (2).
3. Tuck rubber boot on rod assembly (3) into master cylin-
der body (1).
1
2
4
3