Table of Contents
Advertisement
Tools Mode
Transporting the Scanner
The scanner module must be locked when transporting the DP-C106 to
ensure against damage. Locking the module keeps it from sliding and either
damaging itself or causing damage to other parts of the scanner.
Use the following procedure to lock the scanner module:
1.
Press the Tools button to display the Tools Main Menu on the Copier
Screen.
2.
Using the (
3.
Press the Select button. Password Input is displayed on the Copier
Screen.
4.
Using the Numeric Keypad, enter your Administrator Password. The
numbers display as asterisks (*).
If you make a mistake while entering a password, press the Clear button.
5.
Once the correct password is entered, the Administrator Menu is
displayed on the Copier Screen.
6.
Use the (
selection.
7.
Press the select button. Transporting Scanner selection is displayed on
the Copier Screen.
8.
Use the (
The default setting for transporting the scanner is Off. If you do not wish to
transport the scanner at this time, press the Exit button to return to the
Administrator Menu. The Tools Main Menu is displayed on the Copier
Screen. To exit Tools Mode, press the Tools button.
9.
The Copier/Printer locks the scanner module. The copier then prompts
you to turn Off the power.
10. Turn the power Off and proceed with moving the scanner.
For directions on turning the power Off, go to the Setting Up the DP-C106
chapter.
Once the scanner module is locked, you cannot return to any copy functions
until the scanner power is switched Off and then On again. This is the only
way to unlock the scanner module.
68
) ARROW buttons highlight the Admin menu selection.
) ARROW buttons to highlight the Transporting Scanner
) ARROW buttons to select On.
Advertisement
Table of Contents
