Table of Contents
Advertisement
Network Problem Solving
Network Problem Solving
Because the DP-C106 server is part of the Printer, most references in this
chapter are simply to the Printer. The word server is used to refer to network
servers.
Problems During Setup from the Control Panel
If you have difficulty printing the test page and no message is displayed,
perform the following steps:
1.
Check the Printer status.
2.
Use the table below to attempt to resolve the problem.
3.
Try printing again.
Symptom
None of the Control
Panel lights are On.
Nothing is displayed on
the Control Panel
screen.
The PROCESSING
indicator does not light
when a print job is sent
over the network or the
parallel connection, or a
copy job is in progress.
Possible Cause
The power switch has
not been switched On.
The Power Cord is not
securely attached.
There is no power to the
electrical outlet.
The interface cable is
not connected properly.
Either the print driver is
not installed or the
server has not been
correctly set up.
Possible Solution
Switch On the Printer
power switch.
Ensure that the Power
Cord is securely plugged
into the wall and into the
Printer.
Ensure that the outlet is
switched On.
Ensure that the network
or parallel cable
connector is properly
attached.
Check the settings on the
Host Server.
Problem Solving
111
Advertisement
Table of Contents
