Konica Minolta bizhub 500 Service Manual page 443

5. FIRMWARE VERSION UP
B. ISWTrns error list
The ISWTrns displays messages when an error is shown or the operation is completed. The table below shows
the contents of the message and the status of the ISWTrns.
Message
Cannot open a checksum file
Cannot read a checksum file
Cannot open a file
Cannot open the LPT port
Communications port setup
acquisition error
Communications port setup error
Cannot open a send file
Cannot send a Term Test file
Unsuccessful file transmission
Unsuccessful transmission to the
LPT port
Invalid folder name
Default data folder is not set.
Please select folder.
Unsuccessful thread creation
No send file available
Unable to copy several files
Send file not found, or invalid file
name in the folder. Check.
110
Status of the ISWTrns
Opening of a checksum file failed. Possible causes include a corrupted
file and a file in use.
Loading of a checksum file into memory failed. Possible causes include
a shortage of memory and an OS problem.
Opening of a send file failed. Possible causes include a corrupted file
and a file in use.
Opening of the LPT port failed.
A call to GetCommState failed.
A call to SetCommState failed.
Opening of a send file failed. Possible causes include a corrupted file
and a file in use.
Transmission of a communications test block failed.
1. The main body is not ready to receive.
2. The cable is out of position.
3. Transmission of the wrong send file was attempted.
The transmission of a send file failed. Possible causes include a cable
out of position.
Output to the LPT port failed. Possible causes include a cable out of
position.
An invalid folder name was entered. Start a folder name with a drive
name, such as C:\.
A data folder is not set in ISWTrns.INI. This message is displayed when
ISW Trns launches for the fist time.
The creation of a thread failed.
No file to copy file is selected or exists in the folder.
1. The destination folder does not exist.
2. When the overwrite check box is not checked, an attempt is made to
copy to a file having the same file name.
3. An attempt is made to overwrite a protected file.
4. Any other cause (such as a file being used by another application or
OS problem)
The number of divisions of a send file recorded in the checksum file and
the number of files actually existing do not match.
1. A file having an invalid file name exists in the data folder. Delete possi-
bly invalid file names from the folder list.
2. The number of files in a divided file is wanting. Identify the wanting
files in the folder list and recopy them.
3. When the checksum file is damaged, copy it to the folder again.
Field Service Ver1.0 Feb.2006