Konica Minolta bizhub 500 Service Manual page 252

Theory of Operation Ver1.0 Feb.2006
B. Paper exit roller separation control
1.
To stack [1] paper in the handling tray [2] while in the staple mode, FS start signal turns ON, and the paper
exit roller release motor (M13) turns ON. After the pressure of the paper exit roller [3] is released and the
paper exit roller is separated [4], M13 turns OFF.
2. After completion of the stapling operation, M13 turns ON again when the fusing exit sensor (PS3) of the main
body detects the trailing edge of the 2nd paper of the next copy. M13 pressures [7] the paper exit roller to
nip the paper [5], then M13 stops and the paper exits.
[3] [4]
[2]
[1] Conveyance to the handling tray
[2] Handling tray
[3] Paper exit roller
[4] Release the pressure of the paper exit roller
[1]
[6] [7]
[5]
[5] Paper
[6] Paper exit
[7] Pressure
5. OPERATION
4521t2c014na
21