Hmi Settings - Kohler KD700 Operation

2.11.3 HMI Settings

Figure 53 HMI settings
The sliders on this screen allow adjustment of the screen brightness during operation and standby. The two sliders are
independent. However, if the brightness in operation mode is near the brightness in standby mode, then the setting of the second
follows the first, as shown. Conversely, if the brightness is increased in standby mode, the brightness during use also incre ases.
Title
Standby mode
Time (min)
HMI connectivity
HMI type *
Mode of operation †
Display blue background of locked button
(selector 0/1) ‡
Remote HMI number †
Addressing mode †
Eth1 IP address †
Eth1 MAC address †
 Several choices available for the parameter
† These parameters only appear if Remote has been selected
‡ This parameter only appears if Remote and Display have been selected
52
Description and possible settings (or selections)
Delay before activation of screen standby mode: from 10 to 600 minutes
Use of HMI connected to the base module: Local, Remote
Use of HMI for remote mode: Full access, Operation, Visualization
When the selector is at 1, the HMI is connected using the access code (see section 9.4 -
Identification)
Remote HMI number: from 1 to 50 in a complete power plant, but limited to 9 HMIs for a
base module
HMI addressing: System, Customer IP, DHCP
Permanent or temporary identification number for the HMI module connected to another
base or to a network (for example: redundant ring)
Unique permanent physical identification number, which is stored in the HMI module
Touch the Modify button
Slide to adjust the screen brightness
during normal operation
Slide to adjust brightness during
standby operation
TP-7070 11/22