Menus 5 And 6; Menu 6.5-Communication - Kohler KD700 Operation

2.12.5 Menus 5 and 6

Except for menu 6.5, communication, menus 5 and 6 are view-only menus that can be seen when logged in as an operator
(1966). The view-only menus are not shown in this document.

2.12.6 Menu 6.5-Communication

Screen 6.5.1-Ethernet
The 6.5.1-Ethernet screen defines the computer addresses for the Ethernet connections for the base module and the HMI
module.
Figure 85 Ethernet Screen
The screen is accessible for modification at the operator level, but only for the TCP/IP configuration section.
Group
Addressing mode *
TCP/IP Settings
DNS server
Base-Eth3/4 IP address * ‡
Base-Eth3/4 MAC address * ‡
Fault Finding
HMI-Eth1 IP address * †
HMI-Eth1 MAC address * †
HMI-Eth2 IP address
 IP = Internet Protocol; MAC = Media Access Control.
† Eth1 = Ethernet port marked 1 at the rear of the HMI module
‡ Eth3/4 = Ethernet ports marked 3 or 4 on the front of the base module
§ DHCP: the DHCP protocol (Dynamic Host Configuration Protocol) allows an APM system to connect to a network, which dynamically
assigns it an IP address
Figure 86 Ethernet Settings
TP-7070 11/22
Title
Choice of address type for the TCP/IP connection: System, Customer IP, or
DHCP. §
IP address of the DNS server. The DNS server is used to make the
connection between an APM802 system and an IP address.
Permanent or temporary identification number for the base module connected
to another base or to a mains.
Unique permanent physical identification number, which is stored in the base
module.
Permanent or temporary identification number for the HMI module connected
to another base or to a mains.
Unique permanent physical identification number, which is stored in the HMI
module.
Not used.
Description and Possible Settings
71