Hmi Settings - Kohler KD800 Operation

2.11.3 HMI Settings

1. Touch the Modify button
2. Slide to adjust the screen brightness during normal operation
3. Slide to adjust brightness during standby operation
Figure 2-43 HMI settings
The sliders on this screen allow adjustment of the
screen brightness during operation and standby. The
two sliders are independent. However, if the brightness
in operation mode is near the brightness in standby
mode, then the setting of the second follows the first, as
shown. Conversely, if the brightness is increased in
standby mode, the brightness during use also
increases.
Title
Standby mode
Time (min)
HMI connectivity
HMI type *
Mode of operation
Display blue background of locked
button (selector 0/1)
Remote HMI number
Addressing mode
Eth1 IP address
Eth1 MAC address
* Several choices available for the parameter
These parameters only appear if Remote has been selected
This parameter only appears if Remote and Display have been selected
TP-7070 8/20
Description and possible settings (or selections)
Delay before activation of screen standby mode: from 10 to 600 minutes
Use of HMI connected to the base module: Local, Remote
Use of HMI for remote mode: Full access, Operation, Visualization
When the selector is at 1, the HMI is connected using the access code (see
section 9.4 - Identification)
Remote HMI number: from 1 to 50 in a complete power plant, but limited to 9
HMIs for a base module
HMI addressing: System, Customer IP, DHCP
Permanent or temporary identification number for the HMI module connected to
another base or to a network (for example: redundant ring)
Unique permanent physical identification number, which is stored in the HMI
module
1
2
3
Section 2 Operation 43