Battery Chargers; Input And Output Modules - Kohler KD700 Operation

4.3

Battery Chargers

Factory-installed battery charger kits are available for KD model generator sets with a single starter or redundant starters. The
20 Amp, 24 VDC Kohler High Frequency Battery is used with these models.
The battery charger sends a fault message to the APM802 controller in the event of a battery charger fault. See TP -7072, Battery
Charger Installation and Operation Manual, for information about fault conditions and for battery charger operation instructions.
Figure 91 Kohler High Frequency Battery Charger
4.4

Input and Output Modules

The following factory-installed modules are available as optional accessories.
•
Analog Input/Output Module
•
Digital I/O Module
•
Thermocouple Input Module
The modules are factory-installed in the customer connection box. Module power and CAN Bus communications with the
controller are factory connected. The communication speed and module CAN addresses are factory set. Do not change the
speed or CAN address DIP switch settings.
The modules are equipped with diagnostic LEDs that can be used for troubleshooting. See the Module Diagnostic LEDs figure.
80 TP-7070 11/22