Nortel Call Recording Card User Manual page 73

September 2007
BootROM loadware upgrade using PCMCIA Card to transfer
loadware to Compact Flash Card
Use this procedure to perform a BootROM loadware upgrade using
PCMCIA Card to transfer loadware to Compact Flash Card.
1 Reboot the card.
2 While the card reboots, when prompted, type jkl to access the bootROM.
3 Insert the PCMCIA card into the faceplate PCMCIA Card slot.
4 Copy loadware from the PCMCIA card (/A:/ drive) onto the compact flash
card (/C:/ drive) as shown in the following example:
copy("/A:/filename","/C:/filename")
5 Remove the PCMCIA card from the faceplate slot.
Note: Do not insert a card in the /A:/ drive when the Nortel Call
Recording Card is in normal operation.
6 At the shell, perform the bootROM, by typing the following command:
upgradePCMCIABoot "/C:/bootROM"<CR>.
Where <Server IP Address> is the IP address of the Nortel Call
Recording Card. <userid> and <password> are the same as the shell
user name/ password on the Nortel Call Recording Card. <path> is the
location on the card where the bootROM loadware is located.
7 After the upgrade is complete, reboot the card.
BootROM loadware upgrade using FTP to transfer loadware to
Compact Flash Card
Use this procedure to perform a BootROM loadware upgrade using FTP to
transfer loadware to Compact Flash Card.
1 FTP the bootROM loadware onto the /C: drive using the same method as
outlined previously for transferring the application load.
2 Reboot the card.
3 While the card reboots, when prompted, type jkl to access the bootROM.
Planning, Installation, and Administration Guide
Upgrade Procedures
73