Nortel Call Recording Card User Manual page 41

September 2007
If, on first bootup of the card, you cannot log into the shell using the default
user name and password, check that the correct software version is on the
card. This is displayed during bootup, see "Sample bootup sequence" on
page 78.
Figure 7:
VxWorks login: crcadmin
Password: crcsecurity
>
> lnIsa_writeSubnetMask "AAA.BBB.CCC.DDD"
value = 0 = 0x0
> lnIsa_progIP "DDD.CCC.BBB.AAA"
value = 0 = 0x0
lnIsa_writeGW "ZZZ.YYY.XXX.WWW"
value = 0 = 0x0
lnIsaIPMethodSet 2
value = 0 = 0x0
You must reset the Card now by either pressing the reset button on the
faceplate or by typing sysReboot at the command line interface. When the
card restarts, you can test the operation of the network interface by using the
ping command.
ping "mm.nn.oo.pp",3
mm.nn.oo.pp is another IP address in the network the Nortel Call Recording
Card can access. The number 3 shows that three ping packets are sent to the
other IP address.
The output is similar to the following example:
> ping "47.85.3.41", 3
PING 47.85.3.41: 56 data bytes
Planning, Installation, and Administration Guide
Command sequence to assign a static IP address
Configuring the Nortel Call Recording Card
41