Nortel Call Recording Card User Manual page 56

Nortel call recording software: user guide

Table of Contents

Test and Debug Capabilities

In addition, if the IXP encounters any failures during its initialization, an

H:XX error code displays. The list of error codes is shown in Table 13:

"HEX display error codes," on page 56:

Table 13:

Code

H:00

H:01

H:02

H:04

H:08

H:10

H:20

H:40

H:80

You can also use the RS232 port to monitor the progress of self tests.

Messages indicating the completion of each self test phase, as well as any

detected faults are printed to this port. Support is provided for boundary

scan and access to the boundary scan interface on the FPGAs.

Status LED

A single red LED on the faceplate indicates the enabled / disabled status of

the card, and indicates the power status on self test.

The LED is OFF if:

the channel capacity of the card is not zero

and

HEX display error codes

Code description

IXP1200 not booting

SDRAM test failure

SRAM test failure

PCMCIA device failure

Network interface failure

Meridian interface failure

DSP interface failure

NVRAM/EEPROM interface failure

PCM connector failure

Standard 1.0

Nortel Call Recording Card

Table of Contents