Nortel Call Recording Card User Manual page 66

Upgrade Procedures
4 Remove the PCMCIA card from the faceplate slot.
Attention: Do not insert a card in the /A:/ drive when Nortel Call
Recording Card is in normal operation.
5 At the shell, upgrade the loadware using the upgradePCMCIA command
as shown in the following example:
upgradePCMCIA("/C:/newexec")
value = 0 = 0x0
Opening file /C:/newexec
File /C:/newexec opened
File Length = 0x0059d1fc
Bank Size = 0x00780000
Updating sector:
0..1..2..3..4..5..6..7..8..9..10..11..12..13..14..15..16..1
7..18..19..20..21..22..23..24..25..26..27..28..29..30..31..
32..33..34..35..36..37..38..39..40..41..42..43..44..file
read complete
Verifying checksum ...
Upgrade completed OK
Reboot the pack to run new loadware
"C:/newexec" is the location of the file copied onto the compact flash
card.
6 After the upgrade is complete, remove the original loadware file
transferred to the card by typing the following from the shell:
rm "/C:/newexec" <CR>
7 Enable the card using overlay 32 on the switch software.
8 Restart the card.
9 After the card restarts, type the following command at the shell:
swVersionShow <CR>
This command displays the current software version running on the card,
for example:
softwareRev: CRC Rel: 0.01
66
Program filename =
Checksum =
length =
/C:/exec
0xdef4797d
0x59d1fc
Nortel Call Recording Card
Standard 1.0
The checksum value
varies between software
loads. Consult the release
notes for the applied
upgrade load to identify
the correct value.