Toshiba MMU-UP0071MH-UL Service Manual page 76

∗ ∗ ∗ ∗ ∗
<RBC-AMTU3 >
(Execute it while the units are running.)
1
Push the ON / OFF
2
UNIT LOUVER
Push the
1-1 1-1 1-1
1-1 1-1
A unit numbers
system address and indoor unit address of the unit.
When 2 or more indoor units are connected to the remote controller (group-controlled units), a number of other
connected units appears each time you push the
To find an indoor unit's position from its address
When checking unit numbers controlled as a group
∗ ∗ ∗ ∗ ∗
<RBC-AMTU3 >
(Execute it while the units are stopped.)
The indoor unit numbers in a group are indicated one after another. The fan and louvers of the indicated units
are activated.
1
Push and hold the
ALL ALL ALL ALL ALL
• appears on UNIT No. on the LCD display.
• The fans and louvers of all the indoor units in the group are activated.
2
UNIT LOUVER
Push the
unit numbers are indicated one after another.
• The first-indicated unit number is the address of the header unit.
• Only the fan and louvers of the indicated indoor unit are activated.
3
Push the button to finish the procedure.
All the indoor units in the group stop.
TEMP.
FILTER
RESET TEST
button if the units stop.
button (left side of the button).
is indicated on the LCD (it will disappear after a few seconds). The indicated number shows the
TEMP.
3
Stop
FILTER
RESET TEST
1
and buttons at the same time for more than 4 seconds.
button (left side of the button). Each time you push the button, the indoor
ON / OFF
Starts
TIMER SET FAN MODE
running
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
button (left side of the button).
UNIT LOUVER
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
– 76 –
1
2
1
2