Toshiba MMU-UP0071MH-UL Service Manual page 73

∗ ∗ ∗ ∗ ∗
<RBC-AMTU3 >
Pair the indoor unit to set and the remote controller one-to-one.
Turn on the power.
1
Push and hold the
LCD starts flashing.
<Line (system) address>
2
Push the TEMP.
3
Push the TIME
(Match the address with the address on the interface P.C. board of the header outdoor unit in the same refrigerant
line.)
4
Push button.
(It is OK if the display turns on.)
<Indoor unit address>
5
Push the TEMP.
6
Push the TIME
7
Push the button.
(It is OK if the display turns on.)
<Group address>
8
Push the TEMP.
9
Push the TIME
individual, set the address to
Individual : 0000
Header unit : 0001
Follower unit : 0002
10
Push the button.
(It is OK if the display turns on.)
11
Push the button.
The address setting is complete.
( flashes. You can control the unit after
SETING
SET DATA
TEMP.
2, 5, 8
11
FILTER
RESET TEST
1
, and buttons at the same time for more than 4 seconds.
/ buttons repeatedly to set the CODE No. to
/ buttons repeatedly to set a system address.
/ buttons repeatedly to set the CODE No. to
/ buttons repeatedly to set an indoor unit address.
/ buttons repeatedly to set the CODE No. to
/ buttons repeatedly to set a group address. If the indoor unit is
0000 0000 0000 0000 0000
; header unit,
SETING
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
0001 0001 0001 0001 0001
; follower unit,
has disappeared.)
– 73 –
Code No.
3, 6, 9
4, 7, 10
12 12 12 12 12
.
13 13 13 13 13
.
14 14 14 14 14
.
0002 0002 0002 0002 0002
.