Slim Duct - Toshiba MMU-UP0071MH-UL Service Manual

11-2. Slim Duct

WARNING
Be sure to stop operation of the air conditioner before
work and then turn off switch of the breaker.
No. Part name
1. Detachment
Suction
panel
1) Holding the suction panel with your hand, remove the
screws fixing the panel in place.
(UP007~012: M4 × 0.39" (10mm) 7 pcs)
(UP015~018: M4 × 0.39" (10mm) 9 pcs)
NOTE)
• Be careful that the suction panel doesn't fall while at work.
• For the back air intake, remove the screws
(2 locations) used to fix the fan case (lower) in place as
well.
2. Attachment
1) While holding the suction panel with your hand so that
the panel does not fall off, tighten the screws that you
removed in step 1-1) of "
1. Detachment
Terminal
cover
1) Slightly loosen the screw holding the terminal cover in
place.
(M4 × 0.39" (10mm) 1 pcs)
2) Lifting the terminal cover upward, to detach the
terminal cover.
2. Attachment
1) Insert the claws on the down side of the terminal
cover into the hook part.
2) Insert the cover in the gap between the terminal box
and screw that you loosened in step 1-1) of "
Terminal cover" and tighten the screw to fix the cover
in place.
Be sure to put on gloves during working time;
otherwise an injury will be caused by a part etc.
Procedure
Suction panel."
– 137 –
CAUTION
Under air intake
Back air intake
Cover of electrical
control box
Remarks
Suction panel
Suction panel
Screws
screw
Hook part